Sauder North Avenue Serie Manual Del Usuario página 3

Step 1
1
4
D
B
1
å
IMPORTANT: Because of the edges of some parts
before assembly may be sharp, please handle
unassembled parts carefully.
å
Assemble your unit on a carpeted floor or on the
empty carton to avoid scratching your unit or the floor.
å
Fasten the ENDS (B and C) to the BRACES (D).
Tighten four 1-3/16" HEX HEAD SCREWS (1)
using the SMALL L-WRENCH (4).
å
NOTE: Be sure the BRACES (D) are oriented correctly
according to the sticker on the BRACES.
å
NOTE: Do not completely tighten the 1-3/16" HEX
HEAD SCREWS (1) till after the CUSHION (A)
is fastened.
3
å
Carefully stand your unit upright.
å
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. Clean with a damp cloth. Wipe dry.
And to celebrate, why not share your success story at sauder.com or
425190
1
1-3/16" HEX HEAD SCREW
(4 used in this step)
C
D
www.sauder.com/service
2
3
C
å
Flip the unit upside down as shown.
å
Fasten the CUSHION (A) to the ENDS (B and C).
Tighten six 25/32" HEX HEAD SCREWS (2) using the
LARGE L-WRENCH (3).
å
NOTE: You should start each SCREW a few turns
before completely tightening any of them.
å
NOTE: Finish tightening the 1-3/16" HEX
HEAD SCREWS (1).
2
25/32" HEX HEAD SCREW
(6 used in this step)
B
A
2
Pro Tip: Lift with your
legs. And, you know,
your arms.
Page 3