Publicidad
Insert 2 x new AAA (LR03) batteries
‚
(15), paying attention to the polarity
thereof.
Replace the battery lid (14) and re-
‚
tighten the screws (16).
HARNESS ATTACHMENT
Elastic strap
Insert the one end of the elastomer
‚
strap through the strap harness
attachment bars (8) as shown in (17).
Pass the other end of the elastomer
‚
strap around the webbing on the
harness you wish to attach it to.
Clip & coiled lanyard
Attach the coiled lanyard to the
‚
lanyard attachment point (11) on the
fieldSENSE60.
Pass the other end of the coiled
‚
lanyard through the harness clip
mechanism as shown in (19), pulling it
back to clip in place as shown in (20).
4
Securely close the elastomer cover
‚
to ensure the dust & moisture seal
remains intact.
Feed the other end of the elastomer
‚
strap through the bars as above.
Pull on both ends until securely
‚
fastened to the webbing.
Set the rear clip section behind the
‚
webbing you wish to attach to and
press the front clip section firmly
into it until both ends clip (21).
The fieldSENSE60 can now be
‚
pressed into the clip and easily
removed as needed with a single
handed operation.
Publicidad
