JALEXANDER JAE252 Manual De Instrucciones

MODEL #: JAE252 /JAE252-T20
LED FLOOR LAMP
IMPORTANT SAFETY INSTRUCTIONS
Read and Save:
1. Do not install non-factory wiring or any other electrical
components. Altering or modifying the lamp in any way
will render the product unsafe.
2. To prevent bad connections, avoid pulling wiring
connections when removing contents from package
or during installation.
3. This lamp is approved for indoor use only.
4. This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
--
Reorient or relocate the receiving antenna.
--
Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
--
Consult the dealer or an experienced radio/TV
technician for help.
5. Do not hang any object from the shade, light switch or
any lamp part. Lamps are not designed to support
additional weight.
BULB REPLACEMENT
Integrated LED bulb replacement not required.
CLEANING AND MAINTENANCE
1. To clean:use a soft, dry cloth only.
2. Do not use chemical or abrasive cleaning solutions.
)
ASSEMBLY& OPERATING INSTRUCTIONS
1. Carefully unpack and lay all parts on a clean, level
surface.
2.
Connect the bottom arm (B) and the base (D) with the
lock washers (I) and big screws (C),
the screws (C) using the long Allen wrench (K) supplied .
3. Insert the lamp head (A) into the bottom arm (B).
Insert the small screws (E) into the aligned holes, then
tighten the screws (E) with the short Allen wrench (F)
supplied .
4. Insert the DC jack of the power cord (G) into the power
adaptor (H). Then connect the wall plug adapter (H) to
the electrical outlet.
5. Use the touch switch on the lamp head (A) to adjust
the brightness to meet your needs.
NOTE: Touch Switch with Three Step Dimming
Low, Medium, High, and Off.
then tighten