Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2. Loosen the telescoping boom coupler (1) and move the
shaft to the desired position.
3. Tighten the coupler.
11
MAINTENANCE
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
Use only the replacement parts and accessories of the initial
manufacturer.
11.1
GENERAL INFORMATION
Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
•
Stop the machine.
•
Remove the battery pack.
•
Cool the motor.
•
Store the machine in cool and dry place.
•
Use correct clothing, protective gloves and safety glasses.
11.2
CLEAN THE MACHINE
•
Clean the machine after use with a moist cloth dipped in
neutral detergent.
1
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
English
•
Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
•
Keep the trimmer head free of grass, leaves, or excessive
grease.
•
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
•
Do not spray water onto the motor and electrical
components.
11.3
REPLACE THE SPOOL
1. Push the tabs on the sides of the trimmer head at the same
time.
2. Pull and remove the spool cover.
SPOOL
COVER
3. Remove the remaining spool.
4. Put the spool in the spool housing.
Make sure that you put the cutting line in the slot on the
new spool and extend the line approximately 15 cm before
you install the new spool.
10
TABS
SPOOL
NOTE
Publicidad
