Eurocave Modulotheque Instrucciones De Montaje página 10

F ( 9)
eet mv
Abutting columns of Modulotheque share a pair of feet (see Pedestal Module figs. 5 and 6) Thus to enable you
to assemble a run of abutting columns each Pedestal module (MV2) is supplied with 1 pair of feet. You need 1
PART
extra pair of feet to complete the run or for an isolated single column. See installation and assembly (Chapter
x2
MV2 or MV17).
P m (
edeStal odule mv
1
FASTENINGS
ax8
+ 2 foot supports for the 1st module (MV9)
TOOL REQUIRED
2
(supplied)
PARTS
A
4
B
5
Cx2
6
4
GB
2/ 2 40)
mv l
1st MODULE
A
1
Position the foot supports (C) (4 for the
first pedestal module and just 2 for every other
abutting pedestal) in the grooves provided, lining
them up with the holes in the wooden pedestal.
a
Screw together diagonally until tight, using 2
screws (a).
C
a
2
Place the module on the floor and set the level
and height if it is to be a single or initial module.
3
Locate the rack (B) in its housing.
B
3
ADDITIONAL MODULES
4
Line up the module with the previous module
and locate the previous module's foot supports in
the grooves of the new basic module.
5
Line up the holes and insert the 2 screws (a) in
the remaining holes in each foot support.
6
Check the height and level of the assembly.
7
Locate the rack (B) in its housing.
7
PART
bx4
ax2
cx2
ex2
dx6
fx2
TOOL REQUIRED
PARTS
A
B
Bx2
C
ASSEMBLY
FASTENINGS
gx4
B
B m
aSic odule
ASSEMBLY
1 B
1
Fit the 6 dowels (d) and the 2 connecting bolts
(e) in the sides (B). Place the 2 bolt locks (c) in
the back piece(C).
e Fit the back piece (C) on one side (B).
C
Turn the bolt lock (c).
Fit the rack (A) onto the 2 dowels (d).
Push the 2 screws (b) into the rack and screw
together the assembly.
d Repeat the same procedure on the other side (B).
c
d
b
A
b
2
VERTICAL ASSEMBLY
2
(Pedestal or Basic).
Fit the basic module onto the lower module.
Place the 2 securing plates (a) on the pedestal
module and screw together.
a
f
3
3
link them using 4 linking screws (g). Push the
linking screws into the holes provided in the shelf
support strips on the 2 contacting panels. Tighten
until the 2 panels are flush and in line.
g
4
4
secured to the wall from the 2nd level using 2
securing screws (not supplied) suitable for the
wall type.
To be wall mounted
( 1/ 1 40)
mv mv l
Position the 2 dowels (f) in the lower module
When the 2 modules abut, you will need to
The basic modules above the first should be
5
GB