Publicidad
Idiomas disponibles
Idiomas disponibles
6. REPLACE COOKTOP
Place the cooktop back into position and attach
Phillips screwdriver.
7. TEST COOKTOP BURNERS
Push and turn the appropriate burner control
knob counterclockwise to the HI position.
Turn burner control
knob counterclockwise
Turn the ignition knob clockwise continuously
until the burner is lit.
If air is in the supply line, it may take up to a
minute for the air to purge and the burner to
light.
The flame may burn yellow for a few seconds,
then it should turn blue. If the burner continues
to burn mostly or completely yellow, see
technician.
Rotate the burner control knob to LO. Make
sure that the flame completely surrounds the
burner. There should be a flame at the burner
ports and no air gap between the flame and
the burner. If the burner does not meet this
criteria, see "Troubleshooting" or contact a
Repeat these steps to test each burner.
49-2001047 Rev. 4
Installation Instructions
8. TEST OVEN BURNER
Pull the oven handle to open the door.
Push and turn the oven control knob
counterclockwise to the
Keep the oven control knob pressed and rotate
the ignition knob clockwise continuously until
the oven pilot is lit. The oven pilot is located at
the rear right of the bake burner and is visible
from the front of the oven. If air is in the supply
line, it may take over a minute for the air to
purge and the oven pilot to light.
Once the oven pilot is lit, keep the oven control
oven pilot sensor becomes heated.
Release oven control knob and visually confirm
oven pilot remains lit. If oven pilot goes out,
repeat bullets 3 and 4.
Rotate the oven control knob to each
temperature and inspect the burner flame. If
the flame is completely or mostly yellow, see
technician.
9. FLAME QUALITY
The burner flames for the cooktop and bake
burners should be blue with yellow tips. Long,
flames may show signs of an orange tint when
well heated or signs of flickering orange due to
particles in the gas or air.
position.
Publicidad
