ASSEMBLY
WARNING
washer to a power supply until it is fully assembled.
To avoid accidental starting and possible serious
injury, only connect a power supply when the
pressure washer is ready for use.
REMOVING CARTON CONTENTS
WARNING
Do not attempt to operate this product if any items
in the INCLUDED LIST are already assembled when
you remove the carton contents. These items are
not assembled by the manufacturer and should
require customer assembly. Using an improperly
assembled product can be hazardous and could
result in serious personal injury.
l Carefully cut down the sides of the packaging and
remove the carton contents.
l Inspect the carton contents. Verify that all the items in
the INCLUDED LIST are present and undamaged.
l Recycle or dispose of the packaging materials properly.
INCLUDED LIST
See Figure 8.
Pressure Washer, Spray Gun, Lance, Upper Gun
Holster, Lower Gun Holster, Hose Retainer, Cord
Retainer, Nozzles (0°, 15°, 25°, and soap), Turbo
Nozzle, High Pressure Hose, Casters, Quick Start
Guide, User Manual
FIG. 3
A
B
A - Spray Gun
B - Lance
C - Upper Gun Holster
D - Lower Gun Holster
E - Hose Retainer
F - Cord Retainer
G - Nozzles
H - Turbo Nozzle
I - High Pressure Hose
J - Caster
10 | English
Do not connect the pressure
This product requires assembly.
H
C
E
F
D
I
J
If any parts are missing, contact our service team
at service@wpowereq.com or call 1-855-944-3571.
ASSEMBLING THE PRESSURE WASHER
See Figures 4 - 8.
l Hold the pressure washer unit at a slight angle.
l Push the casters into the slots at the base of the
pressure washer until they snap into place.
l Make sure the casters are secure, then return the unit to
a fully upright position.
l Align the tabs on the upper and lower gun holsters with
the slots on the side and bottom of the pressure washer.
Slide the holsters into place.
FIG. 4
A - Slot
B - Caster
G
FIG. 5
A
A - Upper Gun Holster
B - Lower Gun Holster
A
B
B