VENTE-UNIQUE WOBY SBC130-D10 Instrucciones De Uso página 8

1. How to correctly use the water pipe to drain off water?
1）First, fill up the water pipe with water,
2）Second, ensure the water pipe should be full of water then press the two ends of the
water pipe with your fingers tightly,
3）Third, remove one finger from one end of the water pipe; put this end into the water of
the acrylic panel. Meanwhile make sure the other end is still closed.
4）Last, open the other end of the water pipe and turn towards the bucket, the water will
flow out through the water pipe automatically.
1
2. Why Bubbles come out unevenly? What I should do when the bubbles are in
different size?
You could use the adjuster. First, please observe the bubbles,
A: If the bubbles in any one channel of one group are bigger, twist the corresponding
knob counter-clockwise a little,
B: Then twist slightly the rest knobs of one group to get the all bubbles evenly.
the first group
3. Why there is no air expel from outlet of gas?
When you meet this case, please consider that one of the outlets of gas has been
blocked. Turn off all other adjuster to make all air came out from the blocked outlet of gas.
Blockage will be blown out. Then adjust button again to get the all bubbles evenly .Please
refer to Article 2 of the FAQ for operation in details.
4. What kind of water is fit to bubble wall?
Distilled water and pure water are recommended for the bubble wall to prevent the
calcium deposits and algae producing in the acrylic panel. Domestic water is also
available, but it will cause bacterium, algae and calcium deposits.
Deposits will be easy to block the outlet of gas.
FREQUENTLY ASKED QUESTIONS
2
the second group
3
the first group
8
4
the second group