GreenWorks CD40CS15 Manual Del Operario página 7

2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that no dirt in
the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. The whole oil tank will last for 20- 40 minutes.
IMPORTANT
Do not use dirty, used or contaminated oil. Damage
can occur to the bar or chain.
6 TRANSPORTATION AND
STORAGE
Before you move the machine, always
• Remove the battery pack from the machine.
• Keep hands clear of the lock-out button.
• Put the scabbard on the guide bar and the chain.
Before you put the machine into storage, always
• Remove the battery pack from the machine.
• Clean all unwanted material from the machine.
• Make sure that the storage area is
• Not available to children.
• Away from agents which can cause corrosion,
such as garden chemicals and de-icing salts.
7 TROUBLESHOOTING
Problem Possible cause
The guide bar The chain is too
and the chain tight.
become hot and
The oil tank is
release smoke.
empty.
Contamination
causes a block-
age of the dis-
charge port.
Contamination
causes a block-
age of the oil
tank.
Contamination
causes a block-
age of the guide
bar and the oil
tank cap.
Contamination
causes a block-
age of the
sprocket or
guide wheels.
All manuals and user guides at all-guides.com
English
Solution
Adjust the chain
tension.
Add lubricants.
Remove the
guide bar and
clean the dis-
charge port.
Clean the oil
tank. Add new
lubricant.
Clean the guide
bar and the oil
tank cap.
Clean the
sprocket and the
guide wheels.
Problem Possible cause
The motor runs The chain is too
but the chain tight.
does not rotate.
The guide bar
and the chain
are damaged.
The motor is
damaged.
The motor runs
The chain is
and the chain ro-
blunt.
tates, but the
chain does not
The chain is in
cut.
the incorrect di-
rection.
The chain is tight
or loose.
9
EN
Solution
Adjust the chain
tension.
Replace the
guide bar and
the chain if it is
necessary.
1. Remove the
battery pack
from the ma-
chine.
2. Remove the
guide bar
cover.
3. Remove the
bar and saw
chain.
4. Clean the
machine.
5. Install battery
pack and op-
erate the ma-
chine.
If the sprocket
rotates, it means
the motor works
properly. If not,
call service cen-
ter.
Sharpen or re-
place the saw
chain.
Turn the chain
loop to the other
direction.
Adjust the chain
tension.