Publicidad
Step 3
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as
å
shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten two EXTENSION RAILS (40MA) to the UPRIGHTS (C and D). Use four GOLD
å
5/16" FLAT HEAD SCREWS (3S) through holes #1 and #4.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
å
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to fi nd the other
hole that lines up with the hole in the UPRIGHT. Turn a SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the FILE DRAWERS.
å
40MC
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
C
Open end
www.sauder.com/service
3S
4
3
2
1
3
4
D
426484
7
40MA
Open end
1
2
Page 9
Publicidad
