PROFLO PF244 Manual De Instalación página 2

Laundry Faucet Installation Model PF244
1) Locate water supply inlets and Shut off water supplies. If you are replacing an existing faucet, remove the faucet from the
sink and clean the sink surface thoroughly.
2) Locate the hexagon screw where assembled into the center rear leg and Screw off the screw on the center rear leg and
place the faucet in position to mount onto laundry tub then install screw by wrench tighten screw to secure faucet to tub.
3) Connect the water supplies as below two methods. Cold supply on the right and hot supply on the left when facing faucet.
Supply connections: combination union inlet for 1/2" thread or solder,
a). Thread 1/2" iron supply pipe into union. Slide union nut over supply pipe and use wrench to tighten.
b). Solder copper supply pipe to union. Slide union nut over supply pipe and use wrench to tighten.
4) Turn on hot and cold water supplies and turn on handle to full position for a couple of minutes. Check if any leaking.
1
4
7
10/07/13 REV.A
2
5
2
3
6
1. Hose thread adapter & aerator
2. Spout
3. Union inlet
4. Handle
5. Stem
6. Mounting screw
7. Handle screw
www.PROFLO.com