Publicidad
Idiomas disponibles
Idiomas disponibles
EN
1
DESCRIPTION
1.1
PURPOSE
This tool is used for polishing and buffing :
•
Cars, boats, RVs, personal watercraft, motorcycles,
hardwood floors, and large furniture.
1.2
OVERVIEW
Figure 1.
1 ON / OFF Switch
2 Battery Slot
3 Application Bonnet
2
GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings, instructions, illustrations and
specifications provided with this power tool. Failure to
follow all instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your battery-
operated (cordless) power tool.
3
INSTALLATION
3.1
UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
•
If parts of the machine are damaged, do not use the
machine.
•
If parts are missing, do not operate the machine.
•
If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
For your personal safety, do not insert battery before the
tool is assembled completely.
4 Polishing Bonnet
5 Battery release button
6 Foam pad
WARNING
WARNING
WARNING
WARNING
English
3.2
ATTACH THE BONNET
Figure 2.
1. Slip the edge of the application bonnet onto the foam pad.
2. Attach the application bonnet to the foam pad fully.
3. Ensure the bonnet is at the center of the foam pad.
3.3
INSTALL THE BATTERY PACK
Figure 3.
•
If the battery pack or charger is damaged, replace the
battery pack or the charger.
•
Stop the machine and wait until the motor stops before
you install or remove the battery pack.
•
Read, understand, and follow the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.4
REMOVE THE BATTERY PACK
Figure 3.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4
OPERATION
Always wear eye protection.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
4.1
START THE MACHINE
Figure 4.
1. Apply the wax (not included) to the application bonnet
evenly.
2. Put the machine on or against the surface being polished.
3. Slide the ON / OFF switch (1) to the O position.
4. Remove the application bonnet then attach polishing
bonnet to start polishing after waxing.
Use two hands when operating the machine. Using one
hand could cause loss of control and result in serious
personal injury.
4
WARNING
WARNING
WARNING
WARNING
Publicidad
