Publicidad
Idiomas disponibles
Idiomas disponibles
8. Open cover by pushing in on the rear, right-side tab with your right hand (1), as seen
in Figure 14, and lifting the cover with your left hand in the center rear of the bagger
cover (2).
2
9. Install the grass bag assembly (3) (664-05104), with the tight mesh panel facing the
tractor, onto the bag support brackets by inserting the front edge in first (1), as shown in
Figure 15, and setting the back edge down (2) until it fits into the assembly.
1
ASSEMBLING AND CONFIGURING THE BOOT
Before installing the boot onto your tractor, components must first be assembled onto the
boot (631-09698). The following instructions are for assembling and configuring the boot:
1. From the inside, put the two hex head screws (738-1225), from bagger boot hardware
pack (689-02199), through the holes at the bottom front of the boot. See Figure 16.
2. Put the mounting rod (747-06309) in place over the hex head screws. Make sure the tip of
the rod is facing out from the boot. See Figure 16.
3. Begin threading the flange lock nuts (712-04064) onto the hex head screws. See Figure 16.
4. Using a 1/2 inch wrench or socket on the screw and a 7/16 inch box wrench on the flange
lock nuts, secure the assembly.
1
Figure 14
2
Figure 15
Figure 16
SET-UP
INSTALLING THE DISCHARGE CHUTE AND BOOT
When installing the discharge chute and boot, two different installation instructions exist.
For the 54 inch fabricated deck units, the boot elbow mounts directly onto the cutting deck.
For the 50 and 54 inch stamped decks, an adapter must first be installed. Be sure to follow the
instructions that pertain to the unit you are installing this bagger on.
54 Inch Fabricated Deck Units:
1. Raise the deck to its highest position.
2. Remove the deck pin rubber protective cap, 1 in Figure 17.
3. Raise the chute deflector (2 in Figure 17) on the deck and hold it while you position the
boot over the chute opening.
4. Insert the end of the boot elbow (3) into the hole provided in the deck wheel mount as
shown in the top right inset of Figure 17.
5. Pivot the boot rearward until the hole in the boot elbow aligns with the pin on the deck.
Move the boot elbow down onto that pin as shown in 4 of Figure 17.
6. Secure the boot elbow to the cutting deck using a wing knob (720-04122) included in
hardware pack (689-02364). Refer to Figure 18.
On 50 and 54 Inch Stamped Decks Units:
1. Raise the deck to its highest position.
2. Remove the deck pin rubber protective cap, 1 in Figure 19.
1
8
2
1
4
3
Do not use this hole!
Figure 17
Figure 18
2
3
Figure 19
Publicidad
