Publicidad
Idiomas disponibles
Idiomas disponibles
3.2.
Preparation for operation
POSITIONING OF THE UNIT
Always use the product on an even, stable, clean, fireproof and dry surface and out
of the reach of children and people with limited psychological, sensory and mental
abilities.
PRODUCT ASSEMBLY
Caution! Use protective gloves during assembly!
1. Place the product on an even surface so that it is possible to unfold the inner
frame.
2. Raise the inner frame (c).
3. Raise the brackets (e) and position them in a way that their holes align with
the holes in the inner frame.
4. Screw both elements together (c and e) (put the gasket on the screw, insert
the screw through the hole in the bracket and the inner frame, put on the
gasket and tighten with the wing nut).
5. Unfold the leg of the outer frame (b) and set it firmly.
6. The product is ready for use.
3.3.
Working with the device
A. Open the safety clamp.
B. Extend the upper beam, rotate it by 90° to allow the beam to lie on the
frames, close the clamp.
C. Place the log on the teeth of the inner and outer frames.
D.
Open the clamp again, rotate the beam to its original position and lower it so
that its teeth firmly hold the log.
CAUTION! The log should be cut from the side marked with the arrow in the
drawing. Heavy logs weighing more than 25 kg should always be carried by at
least 2 people.
Publicidad
