Hansgrohe Mondial 15720 Serie Instrucciones De Montaje página 9

Fault
Insufficient water
Crossflow, hot water
forced into cold water pipe, or
vice versa, when mixer is closed
Spout temperature
correspond with temperature set
Temperature regulation
possible
Safety stop button not operating
Diverter stiff
Diverter leaking
Cause
- Supply pressure inadequate
- Regulator filter dirty
- Shower filter seal dirty
being - Backflow preventers dirty or
leaking
does not - Thermostat
adjusted
- Hot water temperature too low
not - Temperature regulator dirty or
calcified
- For new installations: basic
body
(should be: cold right, hot left)
or installed with 180° rotation
- Spring defective
- Button calcified
- Cartridge damage
- Dirt or sedimentation on valve
seat
English
has not been
incorrectly connected
Remedy
- Check mains pressure
- Clean filters
- Clean filter seal between shower
and hose
- Clean backflow
exchange if necessary
- Adjust thermostat
- Increase hot water temperature
to 42 °C to 65 °C
- Clean temperature regulator,
exchange if necessary
- Install function block turned
through 180°
- Clean spring and/or button,
exchange if necessary
- Exchange diverter
- Clean valve seat or exchange
diverter
preventers,
9