Velleman SG91007 Guia De Inicio Rapido

SG91007 (HAM2007) – THREE-DIGIT ENTRY ALARM + MAGNETIC CONTACT
1. Battery Installation
Remove the screw and lift the cover of the battery compartment. Insert 3 AAA-batteries (not included). You will now
hear two beeps. Press a random key to listen to the sound this produces. Replace the batteries if there is no beep
or if the beep sounds dull and sluggish. Replace the battery cover and screw it down. The best results are achieved
with alkaline batteries.
2. Setting your Personal Code
Insert the batteries. Press the orange function key "F". Enter 333 (default code) and the red LED will light. Enter
your personal 3-digit code. The red LED goes out and one long beep confirms your new code. Follow the same
procedure to change your personal code.
3. Adjusting the Entry and Exit Delays
a) Press F and then the
3 respectively. A single beep confirms the setting.
b) To change the 10-second (default value) exit delay : press F and then the
20 or 30 seconds by pressing 4, 5 or 6 respectively. A single beep confirms the setting.
c) To change the alarm duration (default value 30 sec.) : press F and then the
of 30 or 60 seconds by pressing 7 or 8 respectively. A single beep confirms the setting.
4. Installation
Select the entrance to be covered. Use the supplied screws or the double-sided adhesive pads to attach the
mounting plate to the wall within 10cm of the doorjamb and slide the unit onto the plate.
Mount the magnetic contact on the edge of the door. Use the screws or the pads to mount the wired contact on the
doorjamb as close to the magnetic contact as possible (max. 1cm).
5. Doorbell Function
The doorbell function only works when the alarm is not armed. Press F and then
sound twice to confirm that the device is in the doorbell mode. Wait 15 seconds for the unit to warm up. The ding-
dong sound will be produced twice every time the door is opened. To deactivate the doorbell function : press F and
press . Two beeps confirm that the doorbell function has been deactivated.
6. Panic Alarm
In case of an emergency, you can trigger an immediate alarm by pressing F and
will sound for 30 seconds.
7. Arming & Disarming the Alarm
Arming the alarm : Press F, followed by the
Disarming the alarm
8. Operation
The red LED starts to flash when the door is opened. The alarm will sound for 30 (or 60) seconds after the delay
time and reset itself automatically after 3 seconds unless you press F and enter your PIN code first. If the door or
window remains open, the alarm will be activated for 30 (or 60) seconds, it will reset itself after 3 seconds and go
off again. This will continue until the door or window is closed. When you are entering your PIN code, you should
check whether the red LED comes on to confirm every one of the three digits you enter. Note that you can only use
the alarm if the device is in the alarm mode.
HAM2007
key. Select an entry delay of 3 (default value), 15 or 30 seconds by pressing 1, 2 or
duration of the exit delay you have set. Close the door/window in the meantime. The alarm is
armed when the device no longer beeps.
: Press F and enter your personal 3-digit PIN (Personal Identification Number) code and
the alarm will be disarmed. Note that you can only disarm the alarm when the device is
in the alarm mode.
key. The red LED flashes and the device beeps for the
1Sh
key. Select an exit delay of 10,
key. Select an alarm duration
. The ding-dong chime will
simultaneously. The alarm
VELLEMAN