Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
5. With the pressure washer on, pull the trigger on pressure washer gun to spray foam.
6. Do a test shot away from the object you are spraying to ensure the pro foam cannon is attached properly
and you are getting the spray pattern you want.
CAUTION:
Do not point the pro foam cannon at people or animals as it can cause injury.
7. When finished, shut off the pressure washer. Relieve any pressure left in the line by pulling trigger on
pressure washer gun. Remove the pro foam cannon from the quick connect fitting.
8. Remove the sprayer from the bottle. Turn sprayer "counterclockwise" until you can remove it from the bottle.
9. Empty any remaining soap mixture.
CARE AND MAINTENANCE
1. To clean the pro foam cannon, take the sprayer (without
the bottle) and hook it back up to pressure washer gun
or wand. Place intake tube into a bucket of clean water.
Turn on pressure washer and run clean water through
the sprayer.
2. When done, turn off pressure washer, disconnect
sprayer and dry.
TROUBLESHOOTING
PROBLEM
Connections leak.
Low soap output.
WARRANTY
TWO YEARS LIMITED WARRANTY
The manufacturer warrants this product against defects in materials and workmanship for two (2) years from
date of purchase. If within this period a product is found to be defective in material or workmanship, the
product must be returned with a copy of the bill of sale as proof of purchase to the manufacturer. This warranty
does not cover the product becoming defective due to misuse, accidental damage, improper handing and/or
installation and specifically excludes liability for direct, incidental or consequential damages. As some states
do not allow exclusions or limitations on how long an implied warranty lasts, the above exclusions and
limitations may not apply to you. This warranty gives you specific rights and you may also have other rights
which vary from state to state. For warranty service, call +1 (866) 870-9930, 9 a.m. - 5 p.m., EST, Monday -
Friday.
POSSIBLE CAUSE
1. Inlet plug loose.
2. Bad coupler.
1. Too little soap added.
2. Filter is clogged.
1
CORRECTIVE ACTION
1. Retighten fittings.
2. Replace coupler.
1. Check manufacturer's recommended.
2. Try cleaning the filter.
3. Replace the filter.
2
Printed in China
www.surfacemaxx.com
Publicidad
