ledscom LC-L-169-W Instrucciones De Montaje página 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
Remove the cover (1) from the mounting
plate (2).
3. Drill two holes (6 mm Ø) in the wall and
insert if necessary. suitable dowels. The
positioning of the holes should correspond
to those of the screw holes , or. If
necessary, make sure that the dowels are
flush with the wall (only when mounting
without a standard flush-mounted box).
Connect the wires of the light according to
"Figure 2".
Now place the mounting plate (2) on the
flush-mounted box/mounting surface and
fix it in place using the two screws (3).
Press the cover (1) back onto the mounting
plate (2).
7. Turn the power back on. The installation
is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English
Figure 1
1: Aperture
2: Mounting plate
3: Screws
Figure 2
Wall lamp (LC-L-169-W) - Assembly instructions
4: Screw holes variant 1 (compatible with
standard flush-mounted box)
5: Screw holes variant 2(compatible
withstandard flush-mounted box)
6: Screw holes variant 3
03/2023