cam Panoramic S168 Manual De Instrucciones página 21

PANORAMIC-marzo 2020_Layout 1 16/03/20 11:48 Pagina 21
e can.
. 7b. Find the Belt clip and remove the
e belt.
e 7c. Pull out the belt from the slots.
k 7d. Take out the buckle.
e 7e. Take out the belt lock-off.
e Installation of Group 2/3 and it is for
3 children whose weight between 15-
e 36kg.
8a. Before the installation, please take
d away the harness system of baby car
n seat. Do not use any load bearing
e supports other than those described in
the instructions and marked in the child
g restraint. The belt must be routed as
shown in the manual.
d 8b. Press the ISOFIT release button and
s push the ISOFIT connectors forward as
far as possible.
e 8c. Push the ISOFIT connectors directly
d into the anchorages until you hear an
3 audible sound "click".
e
8d. If the ISOFIT connectors are
y correctly installed, the release button
n will pop out, and you can see a clear
green mark on it. Grasp the seat body
e to check the seat if it is fastened tightly
e or shakes. If the seat shakes and the
e ISOFIT connectors are pulled out,
please repeat the above steps and
s install again.
8e-8f. Place your child into the baby
T car seat and let the car belt pass the
, belt guide. Fasten the car belt with an
l audible sound "click". Make sure the
lap belt is stretched as low as possible
r over the child's hips, within the belt
guides, and fastened into the buckle.
e The shoulder belt must cross midway
3 between child's shoulder and neck.
e Please make sure that any lap strap is
worn low down, so that the pelvis is
d firmly engaged.
n
e Cleaning
Replacement seat covers are available
from your retailer and or at branches.
s The cover can be removed and washed
p with a mild detergent using the
washing machine's cycle for delicate
, items (30°C). Please observe the
instructions on the washing label of
INSTRUCTIONS FOR USE
the cover. The colours of the cover may
fade if washed at more than 30°C. Do
not spin, and never tumble dry in an
electric clothes dryer (the fabric may
separate from the padding). The
plastic parts can be cleaned using
soapy water. Do not use harsh cleaning
agents (such as solvents). The harness
can be removed and washed in
lukewarm soapy water.
Checklist
Check that the harness belt system fits
properly and tightly around your child
and that the shoulder belts are at the
correct height. Check regularly that the
belt in the baby car seat is not
damaged. If it is damaged do not use
your product in any circumstances and
contact your retailer. Check that you
have secured your baby car seat with
the seat belt.
questions, please
supplier.
Make sure that you have the following
details to hand:
underneath, mark and type of vehicle
and seat on which the baby car seat
used, age and weight of your child.
SPARE PARTS
1
Completely soft goods
2
Set soft protector
3
Lower carter
4
Top Tether
5
5 points belt
6
Base Isofix assembled
7
Head adjuster assembled
8
Seat chell assembled
9
Side clip
If you have any
contact your
serial number
20