TCL RF436GM1110 Instrucciones De Funcionamiento página 14

Failure analysis
The following items shall be inspected before occurring failures which require
maintenance:
Failures: Refrigerator does not work, the refrigeration effect is poor
Causes: 1. Check the connection of power supply. 2. Check whether the refrigerator is
exposed to direct sunlight or whether there is heat source nearby. 3. Check whether there
is heat dissipation space around refrigerator.
Remedies: 1. Connect the power supply. 2. Move the refrigerator to a place without direct
sunlight and heat source. 3. Leave sufficient space between refrigerator and wall.
Failures: Foods in refrigerating chamber are frozen
Causes: 1. Check whether the setting temperature is too low. 2. Check whether foods with
too much water are too close to the rear wall.
Remedies: 1. Adequately increase the temperature. 2. Move the foods with too much water
to the door side of glass shelf
Failures: There is abnormal sound in refrigerator
Causes: 1. Check whether the bottom of refrigerator is stable. 2. Check whether the
refrigerator is too close to the wall. 3. Check whether the refrigerator touches other
objects.
Remedies: 1. Adjust the bottom adjusting leg to stabilize the refrigerator. 2. Leave
sufficient space around refrigerator. 3. Remove the obstacles.
Failures: There is abnormal odor in refrigerator
Causes: 1. Check whether the foods are sealed for storage. 2. Check whether the
refrigerator is clean. 3. Check whether the foods are stored for too long time.Remedies:1.
Sealed foods for storage. 2. Regularly clean the refrigerator. 3. Do not store foods for too
long time.
Non-failures
Phenomenon: Fever or hot on two sides and spacing part surface between
refrigerating chamber and freezing chamber.
Cause: Refrigerator pipes (condenser, anti-fog pipes) are on two sides and front part of
refrigerator for heat dissipation and to prevent from condensation.
Phenomenon: The door is too tight and not easy to open
Cause: Reopening of the door immediately after closing it is hard because hot air enters
the refrigerator and contracts to produce pressure difference. It is easy to open the door
after a while.
Phenomenon: There is water ripple in refrigerator
Cause: When starting or stopping the compressor, the refrigerant will make such sound;
Water produced after defrosting will also make such sound.
Phenomenon: There is "Click" sound or tick sound in refrigerator
Cause: Shrinkage and swelling of case will make such sound; When the case is cold or the
door is opened, this sound will occur; Phenomenon: There is hum sound in refrigerator
Cause: Running of compressor will make such sound (if the refrigerator is not leveled, this
sound will be louder)
Phenomenon: There is condensation or frosting freezing chamber door surface or
food surface
Cause: Temperature or humidity around the refrigerator is high; The door is opened for too
long time; The foods with too much water are not sealed or tightly wrapped
Phenomenon: There is condensation on the built-in light surface
Cause: Light will produce heat after being lit, and the door is opened for too long time. So
there is temperature difference, and thus the light case will have condensation.
Phenomenon: There is condensation and water mist on body
Cause: Humidity around refrigerator is high, and the moisture in the air will gather in the
case to form condensation
13
EN