Publicidad
Idiomas disponibles
Idiomas disponibles
XR200M -
VIA RADIO MAGNETIC CONTACT BROWN COLOUR
INSERT OR REPLACEMENT OF BATTERY
Before insert a battery , hold down the central button for about 5 seconds, then release it and to insert new battery whatching
that the two LED are turned on for an istant; otherwise, to repeat the operation by holding down the right button for those few
minutes more.
To ensure that resizable wire of antenna, on the left side of the circuit , is positioned in parallel to the battery and that thewire
battery does not interfere with the spring of the Tamper anti-tampering before to close the container.
PROGRAMMING
The programming consists simply into the insertion of the area of belonging identified with a code of three digits,followed
fromsystem Code prpgrammed in the central unit.
To program the transmitter:
To press at the same time the two buttons.
To release the buttons when turn on both LED.
To insert the zone code using the left button for one(1) and the right one for the zero (0).
Sto follow programming procedure, in according to the central XR used :
Installed with XR100
000 - Zone 2
100 - Zone 3
Installed with XR1600
000 - Zone 0
001 - Zone 1
010 - Zone 2
011 - Zone 3
100 - Zone 4
101 - Zone 5
110 - Zone 6
111 - Zone 7
To insert in succession the central unit code of 18 digits,by controlling that the green LED for
the one( left button) and red for zero (right button).
The end of programming is signaled from lighting for a moment of two LED.
If you stop the code for more than 30 seconds the Xr200 exits automatically from programming without to change any
code.
Warning: if you insert a central code composed of a sequence of all one e un codice centrale composed from a
sequence of all one or of all zero the XR200M signale error with a lighting at the same time of two LED and doesn't
accept the code.
SIGNALISATION DISCHARGED BATTERY
For every opening of contact:
GreenLED : normal functioning
Red LED : discharged battery
4
XR200M
Installed with
000 = zone 1
100 = zone 2
010 = zone 3
110 = zone 4
001 = zone 5
101 = zone 6
011 = zone 7
111 = zone 8
Installed with XR500
000 - Zone 2
100 - Zone 3
010 - Zone 4
2S
}
PROTEC4GSM
PROTEC8GSM
TM800GSM
POWER8
security
"1"
"0"
Publicidad
