Trust START-LINE AEX-70 Manual Del Usuario página 7

AEX-701 WIRELESS SIGNAL REPEATER
EN
1. Starting point
Make sure the Trust Smart Home transmitter is assigned to the Trust Smart Home receiver before
proceeding. Read the receiver's manual for the code learning procedure.
2. Install batteries:
1. Detach the foot stand with a screwdriver.
2. Remove the screws to open the battery compartment.
3. Insert 2x 1,5V AA alkaline batteries with the correct polarity into the battery compartment.
3. Activate learn mode
Press the learn-button for 1 second. The learn mode will be active for 15 seconds and the LED-indicator
on the front will blink.
4. Assign Trust Smart Home transmitter code
While the learn-mode is active, send an ON-signal with any Trust Smart Home transmitter.
The LED-indicator will slowly blink twice to confirm the code has been received.
5. Close battery cover and click-on the foot stand.
Tighten all screws to ensure waterproofness.
6. Mounting inside or outside
Use the foot for horizontal placement or use the rear slots for vertical mounting.
7. Single code delete
1. Press the learn-button for 1 second. The learn mode will be active for 15 seconds and the
LED-indicator will blink.
2. While the delete mode is active, send an OFF-signal with a Trust Smart Home transmitter to
delete
the transmitter code.
3. The LED indicator will blink twice slowly to confirm code deletion.
1