Publicidad
Idiomas disponibles
Idiomas disponibles
Installation of remote control (sold separately)
When using the remote control fixed to the main unit, follow the instructions below to install it.
In addition, when a wired remote control is installed, remove the cover of the operation box before use.
The remote control may be activated by mistake if the cover remains attached.
1
Remove the 2 screws inside the discharge port, then push the discharge port up to remove it.
2
Remove the 3 screws at the positions shown in the diagram, then push the operation box up to
remove it.
3
Remove the cover of the operation box.
Remove the air discharge port
4
Remove the 2 screws of the operation box, then remove the switch cover.
A arrow view
Remove the screws
Remove the Switch cover
5
Remove the 2 screws from the back of the operation box, then remove the cover with the (black)
bushing.
6
After removing the cover, remove the 2 screws and remove the remote control mounting board
from the front of the operation box.
Bushing (black)
Cover
Remove the 2 screws
9-EN
– 5 –
Remove the cover
Remove the
operation box
A
Remove the 2 screws
7
Push a flat head screwdriver etc. into the groove of the top hook at the back of the remote control,
and remove the back case.
8
Tighten the back case and remote control mounting board together with the screws removed in
4
Step
.
9
Connect the remote control wiring to the remote control terminal block.
10
Pass the remote control wiring through the square hole on the back case, then install the remote
control main unit on the back case.
Screws removed in Step 4
Remote control (back)
11
Pass the remote control wiring through the hole on the operation box, then pull it out to the rear
of the operation box.
Secure the remote control mounting board to the operation box from the back of the operation box with the 2
6
screws removed in Step
.
12
Secure the cover with the (black) bushing removed in Step
Pull out towards the rear
13
Connect the remote control wiring pulled out to the back of the operation box in Step
remote control wiring terminal block "A/B" of the electrical parts box.
For remote control wiring
Terminal Block
Remote control mounting board
Back case
5
with 2 screws.
Secure from the back with the screws
11
to the
10-EN
Publicidad
