Freedom Post Extension Instrucciones De Instalación página 3

Determine the desired nished height of your
1
post. The post extension is 65" long. Cut the post
extension to the desired height.
Remove the post cap from the installed post.
2
Attach the post cap to the end of the extension.
Attach the "J" hooks at the top of the post
3
extension near the post cap.
a. Mark the holes and pre-drill with a
bit and secure with provided #10 x1" long
screws. (Fig 1).
Insert coupler into the bottom of the extension.
4
Tap with a rubber mallet until rmly seated.
Using the pre-drilled holes as a guide secure the
5
coupler to the extension by pre-drilling the 4 holes
with a ⁄ ⁄ ⁄ ⁄ " drill bit and secure with four #10 x 1"
5 5 5
32 32
screws (Fig 2).
a. Attach the post extension by rmly seating the
6
coupler into the top of the installed post. Make
sure the "J" hooks that were installed earlier are
in the correct orientation. Tap top of extension
with a rubber mallet to rmly seat.
b. Using the pre-drilled holes as a guide, secure
the coupler to the extension by predrilling the
4 holes with a
#10 x 1" screws (Fig 3).
⁄ ⁄ " drill bit and secure with four ⁄ ⁄
5 5 5
32 32
⁄ ⁄ " drill ⁄ ⁄
5 5 5
32 32
Fig. 1
Fig. 2
Fig. 3
3