Publicidad
After one day setting is finished, figure d2 (Tuesday) begin flashing, repeat the same steps above
o
to set working hour of each day among d1, d2, d3, d4, d5, d6, d7.
Example 2
•
o
Touch the button
Note: each step must be operated within 2 minutes, or it will exit setting and screen will recover to initial
display.
o
Anti-frost mode: the room temperature is maintained at 5°C to prevent frost formation.
o
Comfort mode: comfortable room temperature, which is achieved with temperature and heating
level settings as required.
•
Motion sensor:
The motion sensor is always activated and deactivated automatically with the prog mode. The
o
symbol
As soon as the device heats up at the set time, the sensor starts to scan movements within a
o
radius of 3m.
o
If no movements are detected, heating will stop after 15 minutes. and will resume as soon as
someone moves within the radius.
Note: The motion sensor is only activated automatically in comfort mode, in anti-freeze mode this
function is not supported.
•
24 hour off timer:
•
When the appliance is heating, press the Timer button twice. The symbols
on the display. Please set the desired off time between 0 and 24 hours with the "+" / "-" buttons.
After five seconds the settings will be saved (symbols will stop flashing) and the display will show
the ambient temperature and the timer countdown.
•
By pressing the Timer button again, you can delete the set off time.
•
Child Lock Function:
o
In working mode,
touch
will show [ ] after setting and will recover to initial display in 5 seconds. Other function is invalid
once child lock function works. Once a button is touched, screen will flash [ ] to remind you child
lock function is working and recover to initial display in 5 seconds.
o
Touch
•
Window function:
o
This function is available in each mode. Please press and hold the button
to activate it. The symbol
Sekunden gedrückt, um die Funktion zu deaktivieren.
o
If the room temperature drops by 5°C within the 10 minutes while the heating function is activated,
the unit will consider this as an effect of an open window. After 30 minutes, the room temperature
is measured again. If the room temperature is the same or lower than before, the heating function
is deactivated. The symbol
Once you have closed the window, please press the button
o
The symbol
•
Restoring the factory settings:
To reset the value settings, in any working mode,
directly instead of
appears on the display.
and
at the same time for 3 seconds to activate child lock function, the display
and
at the same time for 3 seconds again cancels child lock function.
i
will flash again on the display.
or
, to set the comfort mode.
blinkt auf dem Display. Halten Sie die Taste für weitere drei
s shown permanently on the display.
press
and
and
for three seconds
again to reactivate the function.
twice quickly at the same time
will flash
Publicidad
