Graf one2clean Manual Del Usuario página 24

6. Installing the control unit in an external control cabinet
6. Installing the control unit in an external control cabinet
1.
Install the external control cabinet as described in
the installation instructions and establish the elec-
trical connection.
3.
The control unit is secured with the screws and
wing nuts supplied with the cabinet.
5.
The additional air distributor is fitted as described
in 5.4 and 5.5.
Before installing the control unit, a strip of foam rub-
ber must be glued to the back of the control unit.
The compressor is placed on top of the control
unit. Use the rubber bracket for the air connection.
For the power connection, the compressor's con-
nector is plugged into the socket on the control
unit.
For information about starting up the wastewater
treatment system and setting the control unit, refer
to the operating logbook.
24 / 52
2.
4.