ledscom LC-L-128-WW Instrucciones De Montaje página 5

1. Turn off the power before installation.
2. Remove the front of the light by
loosening the two Allen screws (1) (Figure
1).
3. Drill two holes (6 mm Ø) and insert the
supplied dowels (2) there. The distance
between the holes should correspond to
those in the luminaire (Figure 1). Make
sure that the dowels are flush with the wall.
4. Pierce the rubber plug (3) and feed the
230 volt connection cable through the hole
that has now been created. Connect your
connection cable to the luster terminal (4)
according to figure 2.
5. Place your connection cable in the
already opened strain relief (5). Then close
the strain relief to fix the cable.
6. Mount the luminaire on the wall using
the supplied screws (6). To do this, insert
the supplied sealing rings between the
luminaire and the screws.
7. Now close the housing and retighten the
Allen screws (1).
8. Turn the power back on. The installation
is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English
Figure 1
1: Allen screws
2: Dowel
3: Rubber plug
Figure 2
Wall lamp (LC-L-128-WW) - Assembly instructions
4: Luster terminal
5: Strain relief
6: Screws
03/2023