Publicidad
Idiomas disponibles
Idiomas disponibles
Remove used batteries from the unit in the same way you put them in.
Return the batteries to a unit responsible for their disposal.
DISPOSAL OF USED UNITS.
At the end of its useful life, this product should not be disposed of with normal
household waste but should be taken to a collection point for the recycling of
electrical and electronic equipment. This is indicated by the symbol on the
product, operating instructions or packaging. The materials used in this appliance
are recyclable according to their marking. By reuse, recycling or applying other
forms of use of waste machines, you make a significant contribution to the
protection of our environment.
Your local administration will provide you with information about the appropriate
disposal point for used appliances.
TROUBLESHOOTING:
Error
Display
code
message
Error
Motor Error!
01
Error
Line On Teeth!
02
Error
Door Is Not
03
Tied
Reason
1. Engine failure
2. Counting sensor
failure
1. The cable is
wound around the
sprocket
2. Wrong cable
winding direction
1. The door is not
tied
Solution
Return to the manufacturer's service
centre for repair
Return to the manufacturer's service
centre for repair
Open the panel. Press and hold the
"↓" or "↑" button for a few seconds
to rotate the cable drum. Once you
have found the correct position,
untangle the cable from the sprocket.
Press the "MENU" button to clear the
error. The door will perform a
functional test and then return to
normal operation.
Press the "↓" button and pull the
cable until it is fully unwound and
then it will wound in the correct
direction. When the cable is
shortened to the desired length,
release the button. Use the "↑" or
"↓" buttons to adjust the length.
After making the adjustments, press
the "MENU" button to clear the error.
The door will perform a functional
test and return to normal operation.
Tie the door. Wait 8 seconds, the
door will perform a functional test
and then resume normal operation.
Publicidad
