GASPARDO MONICA 250 Empleo Y Mantenimiento página 61

3.9.2 SPEEDY SET
The fertilizer spreader hopper can be equipped with the SPEEDY
SET (Fig. 46), which allows the MINIMAX volume batchers (properly
modified) to be adjusted on each hopper with just one operation.
Regularly check that the sliding hatches are aligned. The distribution
table suitable for this adjustment is shown further on.
TABLE OF DISTRIBUTION QUANTITY (kg/Ha)
CAUTION: the MINIMAX batcher, adjusted to the first positions
(B0÷C0 or 1÷1.5 with SPEEDY SET) may become clogged
because of the small opening, especially if fertilizers with irregular
grain size are used. If the quantity of fertilizer to be delivered
comes within the first positions (darkened lines on the table) get
in touch with the manufacturer. The figures given in the table are
approximate as the specific weight and size of the grains often
vary. In any case, always refer to the specific weight shown on
the product packaging; if this is not given, get in touch with the
manufacturer.
IMPORTANT: on the distribution table, according to the row
spacing, check which pair of pinions are present on the seed
drill (A-B Fig. 47).
To change the pair of pinions, work as follows:
- Open the cover of the box and slacken the chain (1 Fig. 47).
- Put the chain on the required gears and align them.
- Tighten the chain again and close the cover.
IMPORTANT: it is possible to disable the distribution of
insecticide (Microgranulator) by releasing the pin as shown in
Figure 48.
cod. G19502561
USE AND MAINTENANCE
fig. 46
Z20
g
ENGLISH
B
Z15
1
Z13
A
Z10
fig. 47
fig. 48
61