Publicidad
Idiomas disponibles
Idiomas disponibles
effective to use a speed-controlled pump here. Then, only one
limit temperature (the higher one) would apply for a pump with an
asynchronous motor. The limit temperatures are interlocked by
the software so that no adjustment errors can be made.
Parameters to be input:
Three limit temperatures and assigned speed stages
3.9.2
Conductive sensors for level control or other functions
The three available sensors can be assigned to the different
functions by this function. The factory setting is level sensor 1
assigned to level control.
As marked on the board, the following inputs are provided for the
following sensors. Some of the inputs have coloured markings
and are labelled on the board. A status LED on the board is
assigned additionally to every input.
Niv 3 (yellow terminal): For conductive sensor
2606402161/...71/...85; cable length 7.5 m, 25 m, 40 m
Niv 2 (white terminal): For conductive sensor
2606402161/...71/...85; cable length 7.5 m, 25 m, 40 m
GND (blue terminal): second pole of the conductive sensors
Attention: The coloured levers must be pressed down slightly to
insert the wire strands into the inputs of the coloured terminals.
Then, the stripped wire can be inserted.
Pos : 36.67 /Tec hnische D ok umentati on Speck Pum pen/Betriebs anl eitung/Beschr eibung/BADU Omnitr onic _ BADU Om ni Stellantrieb/Par ameter und Batterie @ 10\mod_1508315142095_370.docx @ 152953 @ 2 @ 1
3.10 Parameter and battery
The time is buffered with a battery. The service life of the battery
depends on various factors (device without voltage supply,
temperature, etc.), however it should last a minimum of 5 years.
The status of the battery is shown in the display:
= Battery OK
= Replace battery (CR2032)
If the battery performance declines, a capacitor guarantees the
maintenance of time for a few minutes during a power cut or
battery replacement. All parameters are saved in a
microprocessor and are therefore retained even without a battery.
Changing the battery:
Push the battery out towards the front.
Insert the new battery. "+" pole is on top.
03|2022
Description
EN 35
Publicidad
