Intellinet Network Solutions 509107 Instrucciones página 3

Setup
This product requires an SFP transceiver module that provides fiber optic connections.
1 Insert the transceiver into the media converter and route the fiber optic cable into the transceiver.
2 Route the other end of the fiber optic cable into a suitable port in your fiber optic network.
Maximum length and fiber cable specification depend on the model.
RJ45 & PoE
Connect the UTP port of the media converter to powered RJ45 device; e.g., to a network camera. Cat5e or better
cabling is recommended. The Intellinet Industrial Gigabit Media Converter and PoE++ Injector complies with IEEE
802.3bt/at/af standards. The device can supply up to 90 watts of power to a PoE-compliant powered device.
Fiber
Network
TX RX
LED Status
LED
FX - LNK
TP - LNK
FDX
TP - 1000
LFP
TP - PoE
Gb Fiber (120 km/74.5 mi.)
Function
Fiber link LED
Copper link LED
Copper link Full/
Half Duplex LED
Network speed LED
Fiber link - Link
Fault Pass-through
PoE LED
Example
FX TP
Status
On Fiber port is connected.
Off Fiber port is not connected.
Flashing Sending or receiving data.
On Valid port connection.
Off Connection not established.
Flashing Sending or receiving data.
On Full-duplex mode
Off Half-duplex mode
On Network speeds at 1000 Mbps
Off Network speeds at 100 Mbps
Two communication devices connected
On
and functioning normally
Two communication devices connected,
Off
one with a link failure near the end
On PoE is being supplied to a connected PD.
Off No power is being supplied to a connected PD.
Instructions
Gb RJ45/PoE (100 m/300 ft.)
44 V – 57 V
Description
English 3