Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY OF THE UNIT
The machine should move on a steel I-beam of the appropriate width.
Make sure that the supporting structure on which the device will move is
sufficiently strong. It is forbidden to mount the device on a structure that cannot
be verified in terms of its load-bearing capacity. The responsibility for mounting on
a support structure and for the support structure itself rests with the user. When
placing the device on the supporting structure, special care needs to be taken and
all conditions suitable for safe operation must be ensured.
Place the unit in such a way that the mains plug can be reached at any time.
Ensure that the power supply to the unit corresponds to that specified on the
identification plate!
3.3. Working with the unit
• Measure the width of the rail on which the device is to move.
• The side plates have to be evenly spaced, filling the free spaces on the shafts
with spacers. The wheel width of the device (measured between the inner
surfaces of the wheel flanges) should be about 4 mm larger than the width of the
rail on which it is to move.
• Tighten the hexagonal nuts firmly on both sides of the shafts and secure them
with a clip pin.
• Make sure that the unit is properly close to the rail, each wheel rolls freely and
maintains good contact with the rail surface, and that the side plates are parallel.
NOTE: Before first use after assembling the device, verify its operation by
suspending a light load and rolling the device along the rail several times.
Directions for use
1) The electric motor of the trolley is protected by a thermal switch.
The machine may stop during operation and will not be ready for further operation
before cooling down.
2) Do not exceed the maximum load of the machine.
3) Do not use limit switches as routine points for stopping the device from further
operation. They are emergency devices only.
4) Make sure the load is properly attached to the hook or block.
5) Always keep a safe distance from the load and the rope.
6) The machine is equipped with additional elements enabling the assembly of the
winch. Install the winch on the threaded shafts that connect the side plates.
Publicidad
