Descargar Imprimir esta página

Chauvet Professional MAVERICK STORM 2 PROFILE Guía De Referencia Rápida página 2

Ocultar thumbs Ver también para MAVERICK STORM 2 PROFILE:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

EN
Safety Notes
These Safety Notes include important information about installation, use, and maintenance of the Maverick Storm 2 Profile.
The luminaire is intended for professional use only.
The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than
33.79 ft (10.3 m) is not expected.
If the external flexible cable or cord of this luminaire is damaged, it shall be replaced by a special cord or cord
exclusively available from the manufacturer or its service agent.
The light source contained in this luminaire shall only be replaced by the manufacturer or its service agent or
a similar qualified person.
CAUTION:
This product's housing may be hot when operating. Mount this product in a location with adequate
ventilation, at least 20 in (50 cm) from adjacent surfaces.
When transferring the product from extreme temperature environments, (e.g., cold truck to warm humid
ballroom) condensation may form on the internal electronics of the product. To avoid causing a failure,
allow the product to fully acclimate to the surrounding environment before connecting it to power.
Flashing light is known to trigger epileptic seizures. User must comply with local laws regarding notification
of strobe use.
ALWAYS:
Disconnect from power before cleaning the product or replacing the fuse.
Replace the fuse with the same type and rating.
Use a safety cable when mounting this product overhead.
Connect this product to a grounded and protected circuit.
DO NOT:
Open this product. It contains no user-serviceable parts.
Look at the light source when the product is on.
Leave any flammable material within 20 cm of this product while operating or connected to power.
Connect this product to a dimmer or rheostat.
Operate this product if the housing, lenses, or cables appear damaged.
Submerge this product (IP65). Regular outdoor operation is fine.
Permanently install outdoors in locations with extreme environmental conditions. This includes, but is not
limited to:
Exposure to a marine/saline environment (within 3 miles of a saltwater body of water).
Locations where normal temperatures exceed the temperature ranges in this manual.
Locations that are prone to flooding or being buried in snow.
Other areas where the product will be subject to extreme radiation or caustic substances.
ONLY use the hanging/mounting bracket to carry this product.
The maximum ambient temperature is 113 °F (45 °C). Do not operate this product at higher temperatures.
The minimum startup temperature is -4°F (-20°C). Do not start the product at lower temperatures.
The minimum ambient temperature is -22°F (-30°C). Do not operate the product at lower temperatures.
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.
In the event of a serious operating problem, stop using immediately.
What is Included
Maverick Storm 2 Profile
Seetronic Powerkon IP65 power cable
AC Power
This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.
AC Plug
Connection
AC Live
AC Neutral
AC Ground
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
1
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
2 omega brackets with mounting hardware
Quick Reference Guide
Wire (Europe)
Brown
Blue
Green/Yellow
Maverick Storm 2 Profile QRG Rev. 2
Screw Color
Yellow/Brass
Silver
Green

Publicidad

loading