General Safety Instructions; Machine-Related Safety Instructions - Festool DSC-AG 125 FH Manual De Instrucciones

DSC-AG 125 FH
GB
Original operating manual
1 Symbols
Symbol Significance
Warning of general danger
Risk of electric shock
Read operating instructions and safety
notices!
Wear ear protection.
Wear protective gloves.
Wear a dust mask.
Wear protective goggles.
Wear sturdy footwear!
Disconnect from the power supply!
Do not dispose of as domestic waste.
Tip or advice
Handling instruction
Safety class II
Only place packed cutting disk in Sys-
tainer!
2 Safety instructions
2.1

General safety instructions

WARNING! Read all safety warnings, in-
structions, illustrations and specifications
provided with this power tool. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future ref-
erence.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or bat-
tery-operated (cordless) power tool.
2.2

Machine-related safety instructions

Safety Warnings Common for Grinding, Sanding,
Wire Brushing or Abrasive Cutting-Off Opera-
tions:
a. This power tool is intended to function as a
16
grinder, sander, wire brush, or cut-off tool.
Read all safety warnings, instructions, illustra-
tions and specifications provided with this pow-
er tool. Failure to follow all instructions listed
below may result in electric shock, fire and/or
serious injury.
b. Operations such as polishing are not recom-
mended to be performed with this power tool.
Operations for which the power tool was not de-
signed may create a hazard and cause personal
injury.
c. Do not use accessories which are not specifical-
ly designed and recommended by the tool man-
ufacturer. Just because the accessory can be
attached to your power tool, it does not assure
safe operation.
d. The rated speed of the accessory must be at
least equal to the maximum speed marked on
the power tool. Accessories running faster than
their rated speed can break and fly apart.
e. The outside diameter and the thickness of your
accessory must be within the capacity rating of
your power tool. Incorrectly sized accessories
cannot be adequately guarded or controlled.
f. Threaded mounting of accessories must match
the grinder spindle thread. For accessories
mounted by flanges, the arbour hole of the ac-
cessory must fit the locating diameter of the
flange. Accessories that do not match the
mounting hardware of the power tool will run out
of balance, vibrate excessively and may cause
loss of control.
g. Do not use a damaged accessory. Before each
use inspect the accessory such as abrasive
wheels for chips and cracks, backing pad for
cracks, tear or excess wear, wire brush for
loose or cracked wires. If power tool or acces-
sory is dropped, inspect for damage or install an
undamaged accessory. After inspecting and in-
stalling an accessory, position yourself and by-
standers away from the plane of the rotating
accessory and run the power tool at maximum
no-load speed for one minute. Damaged acces-
sories will normally break apart during this test
time.
h. Wear personal protective equipment. Depend-
ing on application, use face shield, safety gog-
gles or safety glasses. As appropriate, wear
dust mask, hearing protectors, gloves and
workshop apron capable of stopping small
abrasive or workpiece fragments. The eye pro-
tection must be capable of stopping flying debris
generated by various operations . The dust mask
or respirator must be capable of filtrating parti-