Kärcher BR 35/12 C Bp Manual De Instrucciones página 18

Recommended detergents:
Application
Regular cleaning
(even for floors sensitive
to alkalies)
Cleaning dirt from
grease
Basic cleaning (strip-
ping) of alkali-resistant
hard coatings
Basic cleaning (strip-
ping) linoleum
Base cleaner, acidic
Disinfection cleaning
Detergents are available in specialised
stores.
 Close the cover of the fresh water res-
ervoir.
 Place the waste water tank on the appli-
ance.
 Release the star knob for the height ad-
justment of the steering wheel.
 Adjust the steering wheel to the desired
height.
 Tighten the star handle.
 Adjust the dosing of the cleaning solu-
tion in accordance with the soiling and
the type of the flooring material.
 Adjust the rotary handle of the brush
contact pressure to the desired value.
Only adjust the brush contact pressure
when the cleaning head is raised.
Note:
If the appliance pulls forwards too strongly dur-
ing operation, reduce the contact pressure.
 Bring the Eco mode switch into the de-
sired position.
Normal operation: The appliance works
at the maximum brush speed and the
highest suction performance.
Eco: The appliance works at reduced
brush speed and suction performance.
This also reduces the energy consump-
tion. The possible action time with one
charging cycle increases.
18
Detergent
RM 745
RM 746
RM 69 ES ASF
RM 69 ASF
RM 752
RM 754
RM 751
RM 732
Settings
ATTENTION
Risk of damage to the floor covering. Do
not operate the appliance on the spot.
Risk of damage. Lift the vacuum bar before
pulling the appliance backwards over a
longer distance.
 Set the appliance switch to "I".
 Switch on "Detergent" button.
 Press the switch of the suction turbine;
the vacuum process will start.
 Push down the pedal of the vacuum bar
lifting device at the back to lower the
vacuum bar.
 Pull the safety switch towards the steer-
ing wheel, the brush drive and the appli-
cation of the cleaning solution are
switched on (if preset).
 Push the appliance forward until the
parking stand folds up and the cleaning
head touches the ground.
 Move the appliance over the surface to
be cleaned.
Note:
If the steering wheel is turned by 180°, the
appliance also reverses.
Shutting Down the Appliance
 Release the safety switch.
 Drive the appliance forward for another
1-2 m to draw off residual water.
 Push down the pedal of the vacuum bar
lifting device at the front to raise the
vacuum bar.
ATTENTION
Vacuum lips and brush can be deformed
permanently. Always park the appliance
with the parking stand folded out.
 Set the appliance switch to "0".
 Place one foot in the tread and lift the
front of the appliance by pulling on the
steering wheel until the parking stand
folds out.
– 5
EN
Cleaning