Bosch GWX 18V-8 Professional Manual Original página 26

26 | English
(3)
After fitting, check that the edge of the abrasive tool
u
(➍) is fitted correctly, i.e. is no higher than the refer-
ence surface (➎). If the edge is higher than the refer-
ence surface, either the holder must be cleaned or the
abrasive tool must not be used.
Before removing the grinding/cutting/flap disc: Make
sure that the power tool has come to a complete stop.
Removing the abrasive tool
➊ Open the lever (3).
➋ The grinding/cutting/flap disc will be released.
➌ The grinding/cutting/flap disc can be removed.
(3)
Approved abrasive tools
You can use all the abrasive tools mentioned in these operat-
ing instructions.
-1
The permissible speed [min ] or the circumferential speed
[m/s] of the abrasive tools used must at least match the val-
ues given in the table.
It is therefore important to observe the permissible rota-
tional/circumferential speed on the label of the abrasive
tool.
1 609 92A 76B | (16.02.2022)
Max. [mm]
D
125
125
125
75
125
125
82
125
s
α
Rotating the machine head (see figure E)
Remove the battery from the power tool before carry-
u
ing out work on the power tool (e.g. maintenance,
changing tool, etc.). The battery should also be re-
moved for transport and storage. There is risk of injury
from unintentionally pressing the on/off switch.
The machine head can be rotated in 90° increments. In this
way, the on/off switch can be brought into a more favourable
handling position for particular applications, e.g. for left-
handed tool users.
Completely unscrew the four screws (➊). Rotate the ma-
chine head carefully, without removing it from the hous-
ing, into the new position (➋). Screw in and retighten the
four screws (➌).
Dust/Chip Extraction
(3)
The dust from materials such as lead paint, some types of
wood, minerals and metal can be harmful to human health.
Touching or breathing in this dust can trigger allergic reac-
tions and/or cause respiratory illnesses in the user or in
people in the near vicinity.
Certain dusts, such as oak or beech dust, are classified as
carcinogenic, especially in conjunction with wood treatment
additives (chromate, wood preservative). Materials contain-
ing asbestos may only be machined by specialists.
– Use a dust extraction system that is suitable for the ma-
terial wherever possible.
– Provide good ventilation at the workplace.
– It is advisable to wear a P2 filter class breathing mask.
[mm] [°]
b s d α [min
7.2 – X-LOCK – 11,000
4.2 – X-LOCK – 11,000
– – X-LOCK – 11,000
30 – X-LOCK – 11,000
19 – X-LOCK – 11,000
– – X-LOCK – 11,000
– – X-LOCK – 11,000
6 10 X-LOCK > 0 11,000
Bosch Power Tools
-1
] [m/s]
80
80
80
80
80
80
80
80