Publicidad
Idiomas disponibles
Idiomas disponibles
10.5
Hammer Setting
▪
For maximum performance, use a good quality masonry bit for hammer drill, turn the
function mode selector on the impact mode position"
▪
Only use this setting to bore or drill into stone/concrete. The Hammer setting works well
when drilling into materials.
▪
The tip of tool MUST be firmly depressed for the hammer action to engage.
NOTE: Only use a masonry bit when drilling into masonry materials.
11 CLEANING AND MAINTENANCE
11.1
Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
▪
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
11.2
Maintenance
▪
Our machines have been designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends upon proper machine care
and regular cleaning.
12 TECHNICAL DETAILS
Chuck
Power supply
Gear Train
Rotation Speed
Impact Rate
Clutch
Torque
13 NOISE
Noise emission values measured according to relevant standard. (K=5)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration)
Copyright © 2021 VARO
POWXB10070
".
13 mm keyless
20 Volt DC
2 Speed
0-400/0-1300 min-1
0-6000/0-19500 ipm
22+1+1 Positions
30Nm (MAX.)
71 dB(A)
82 dB(A)
Max 3,6 m/s²
P a g e
| 12
K = 1,5 m/s²
www.varo.com
EN
Publicidad
