KitchenAid 5KSMSSA Manual Del Propietário página 5

PRODUCT USAGE
USING THE SAUSAGE STUFFER
1.
Feed meat into the Food Grinder Attachment before sliding the casing on the Sausage
Stuffer Tube. This will eliminate air pockets.
2.
Lubricate the Sausage Stuffer Tube and slide one casing over the Tube, leaving about
10 cm (4 inches) to tie off the end.
3.
Turn the Stand Mixer on to Speed 4 and slowly push the ground meat through the grinder.
Hold the casing firmly as it fills. If air bubbles are created during the fill process, use a pin
or needle to pop the bubble.
4. Run meat through until 10-15 cm (4-6 inches) of casing is left unfilled. Turn the Stand
Mixer to '0' (OFF) and tie the remaining end of the casing, or use a tie string.
For segmented-type Sausage (e.g., bratwurst), twist casing ends in alternating directions
at desired Sausage link length.
NOTE: If using natural casings, it is recommended to first soak them in cold water for
30 minutes to remove excess salt, then rinse several times by running cold water through the
entire length of the casing. Refer to the instruction that came with casings.
CARE AND CLEANING
IMPORTANT: Allow the appliance to cool completely before putting on or taking off parts, and
before cleaning the appliance.
1.
The following parts are dishwasher-safe, top rack only: Large Sausage Stuffer Tube,
Small Sausage Stuffer Tube, and Sausage Stuffer Plate.
ELECTRICAL EQUIPMENT WASTE DISPOSAL
DISPOSAL OF PACKING MATERIAL
The packing material is recyclable and is marked with the recycle symbol
of the packing must therefore be disposed of responsibly and in full compliance with local
authority regulations governing waste disposal.
RECYCLING THE PRODUCT
-
By ensuring this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product.
For more detailed information about treatment, recovery and recycling of this product, please
contact your local city office, your household waste disposal service or the shop where you
purchased the product.
DECLARATION OF CONFORMITY
FOR UNITED KINGDOM
This appliance has been designed, constructed and distributed in compliance with the safety
requirements of UK Legislation: Electrical Equipment (Safety) Regulations 2016, The
Ecodesign for Energy-Related Products and Energy Information (Amendment) (EU Exit)
Regulations 2019. The Restriction of the Use of Certain Hazardous Substances in Electrical
and Electronic Equipment Regulations 2012.
. The various parts
5