Publicidad
Idiomas disponibles
Idiomas disponibles
REGOLAZIONE E PULIZIA
WARNINGS
(See picture 10)
It is most important that this instruction booklet is kept together with the appliance both for future reference and for
reasons of safety. 1. Adults should operate this appliance only. Do not allow children to use the controls or play with it.
2
. It is forbidden to modify in any way the main functions and characteristics of this appliance. . The electrical installation of
the appliance should be carried out by a qualified electrician or other competent person. . Never attempt to carry out repairs
unassisted. Inexpert repairs can cause serious damage and malfunction. . Assistance has to be provided by an authorized
engineer only. Always use original spare parts. . This appliance is not suitable for the storage of basic commodities not
including food-stuffs. . The manufacturers of this appliance accept no responsibility for the consequences of misuse in
7
contravention of these safety instructions. It further reserves the right to carry out improvements without prior notice. 8. Avoid
installing the cabinet directly in line with sunlight. . Never install the appliance near sources of heat (such as radiators,
stoves, etc) and d
rafts (such as windows, doors, ventilation systems, air conditioning, etc ...). 10
free from obstruction for at least 30 cm.
edges.
12
. If damp air or products to be refrigerated should cause ice to form on the evaporator, we recommend stopping the
compressor and placing the goods in special refrigerated containers, kept at the same temperature, until defrosting is
completed;if this is not carried out the compressor will continue to operate leading to a wasteful consumption of electricity
and poor performance.
13
. If the appliance is not working and unused, it is indispensable to keep the door open at least 10 cm.
14. Our products are for internal use only do not install outside restaurants, shops.
1. UNPACKING INSTRUCTIONS
CARDBOARD PACKAGE 1a
from the wooden crate with care.
appliance.
4.
Remove the pallet or crate.
been damaged, and report any damage immediately.
8. Separate the packaging materials to facilitate disposal (See picture 1).
2. INSTALLING
ALL MODELS: 1.
Unpack the glass panes stored inside the tank and on the shelf.
the flank. Tighten the lock screw. . Repeat the operation for the other side.
sides and to the roof with the supplied screws. Place the plastic washer between screw and glass. . Install the front glass by
inserting it in the relevant groove along the edge of the front frame (See picture 2).
3. THE SLIDING PANELS
Using the two sliding panels, the back part of the dome can be closed, for hygienic reasons, whilst working, protecting it from
dust and insects.
1.
Insert the lower sliding panel into the inner guide (below) and place it on the edge of the lamp (above).
2.
Insert the other sliding panel into the outer guide. . Make the two panels slide to their stops, keeping the two holes at the
ends. (See picture 4).
4. CLEANING THE INTERNAL TANK
1
. Remove the protection film from the stainless steel of the tank sides and of the other elements.
soft sponge and neutral detergents. . Dry with a soft cloth.
5. CLEANING THE COVER AND EXTERNAL CLEANING
1.
Remove the protective film from the stainless steel. . To clean use the same products used for the inside.
transparent glasses of the sliding panels and the lamp opal glass protection, avoiding the use of substances containing alcohol
or other solvents which would damage them. Only use a soft sponge damped with water.
6. CONNECTION TO THE MAINS
1. Ensure that mains voltage and frequency are the same as those stated on the rating plate placed at the back of the appliance,
near the control board.
2.
Ensure that the supply socket has the following characteristics:
appropriate for the nominal current, as set out on the rating plate.
differential switch (circuit breaker) with In = nominal value as stated on the rating plate with sensitivity Id = 30 mA. . The
supply cable to the appliance is H05 VVF, designed for internal use. . Ensure that there is no danger of explosion. . Insert
the plug into the socket. (Do not use triple or adapter) . Press the switch to the refrigeration unit so that the green light is lit
up.
6
9
11
. Ensure that the products displayed on the shelves and grills do not hang over the
. Cut the strap and lift up the cardboard package.
2.
Insert the forks of a forklift truck between the appliance and pallet or crate. . Lift the
5.
Place the appliance on a flat and level surface.
7.
Make sure there is nothing left in the package before disposal.
3
3
3
2
6
4
5
WOODEN CRATE 1b
2.
Insert a glass-side in the tank, against
4.
Install the upper lamp-holder, fixing it to the
c)
It complies with the IEC regulations: magnetothermic
4
9
GB
3
. Keep the ventilation grills
. Remove the nails
3
6.
Check that the appliance has not
5
2.
Only clean the tank with a
3.
Clean the
It is properly earthed.
a)
b)
5
It is
3
Publicidad
