Kenmore 1200e Serie Manual De Uso Y Cuidado página 11

be sure to push the Mode button within 10
seconds of the air purifier being woke up.
Fan Speed Button
• Tap the Fan Speed button to cycle the air
purifier through the 5 fan speeds. The fan
speed will show on the display screen.
• Tap the Fan Speed button while the air
purifier is in AUTO Mode or SLEEP Mode
and the air purifier will exit that mode.
Timer Button
• In the working state, tap the Timer Button
once, the current time status will be shown
on the display screen. If there is no timer
set, "00" will be shown on the display
screen. If there is a timer, the remaining
time of the current timer will display in 1
hour increments.
NOTE: When the remaining time is less
than 1 hour, the screen displays minutes,
e.g. 59.
• Timer will lock in the current setting for
1-12 hours. After the time is completed,
the air purifier will automatically turn off.
• Each tap on the Timer button will switch
the screen to the timer display from the
current setting. If you don't continue to
tap within 3 seconds, it will switch back to
the PM2.5 value display. If you continue
to tap within 3 seconds, it will enter the
timer state and add to the timer in 1 hour
increments.
CONTROLS & DISPLAY
- 11 -
• In the standby state, the button can
be used to set the start-up time. In the
power-on state, the button can be used to
set the shutdown time. Restarting the unit
will reset the timer.
+
Filter Reset Button
• The filter life is about 6 months. When
the filter life is about to expire, the last
frame of filter life indicator will flash to
remind user to replace the filters until
the filter life is reset.
• Filter life reset: When the last frame of
filter life indicator flashes, replace with
new filters (page 12-13). Turn on the air
purifier. Press and hold the Filter Reset
button for more than 3 seconds, the
filter life will be reset. All of the filter life
indicator bars will be illuminated.
NOTE: The filter life indicator cannot be
reset before the last indicator bar flashes,
long pressing the Filter Reset Button will not
reset the filter life indicators, only a "Ding"
sound is emitted.
• Forced Filter Life Reset: If the filters are
changed before the last frame of filter
life indicator flashes, to reset the filter
life: Within 30 seconds of powering on,
in the standby state, press and hold the
Filter Reset button and Mode button at
the same time for more than 3 seconds.
All indicators on the screen will flash for
3 seconds to indicate that the filter life is
reset.