Levenhuk Ermenrich Wett MW30 Guia Del Usuario página 4

Ermenrich Wett MW30 Moisture Detector
EN
Please carefully read the safety instructions and the user manual before using this product. Keep away from children. Use the
device only as specified in the user manual.
Getting started
•
Open the battery compartment cover and insert 2 AAA batteries. Close the cover.
•
Remove the protective cap as shown below (Fig. 1).
•
Press (18) to turn the device on. Press (18) and hold it for 3 seconds to turn the device off.
Calibration
To check if the device works correctly, take a test measurement.
Turn the device on. Select the wood measuring mode and wood density grade A. Insert the pins into the measurement holes (Fig. 2). The
measured value will be shown on the screen. If the value is between 16.6% and 20.6%, the device works correctly.
Mode setting
Turn the device on and press (18) to set the measuring mode.
The setting order: wood -> building material
Wood density grade
For Wood calibration tables, see Appendix A (in English). In wood measuring mode, press (17) to set the wood density grade. Density is
classified into eight grades (A–H).
Temperature
Press (16) to switch between °C and °F.
Using
Carefully press the test pins into the material whose moisture level you wish to measure. The level will be displayed as a percentage.
To hold the current measurement on the screen, press (15). The HOLD icon will be displayed. Press (16)/(17) to turn the hold function off and
return to measurements.
Figure 1
Measurement holes
Calibration resistor
(inside)
Figure 2
4