Troubleshooting - Mark LX 50G PRO Manual De Uso

EN

Troubleshooting

Trouble
IF the power
doesn't light up and the laser
doesn't work.
In stand -Alone mode, if the pattern
direction is offset, a part of pattern
was shading beam.
In stand-Alone operation and in the
state of close if the power
red indicator is light up, and the
sound active indicator light isn't light
up.
In stand-Alone operation and in the
state of close if the power
red indicator is light up, and
sound active indicator light is light
up.
In DMX mode, the laser is off and
the DMX signal
unlighted
In DMX mode, the unit can
controlled by the DMX console, but
the DMX signal indicator I
supply indicator
supply
supply
the
indicator is
't be
flashing.
PAG. 10
Solution
Please check the power supply and
the input voltage.
Maybe voltage of the power supply
is too low , causing the motor can 't
work well. Please make sure the
range of the motor
±10V,and please use the low voltage
regulator.
Because sound is too small make for
laser shut off in sound active, please
increase the music
increase audio
sensitivity knob.
Its fault to set up as Slave
please set up as master mode.
Make sure to set up the DMX mode,
and make sure to have a good
connection.
Please make sure the DMX console
and unit have the same channel.
User Manual/Manual de Instrucciones
voltage within
volume or
sensitivity with
mode
LX 50G PRO