Publicidad
Idiomas disponibles
Idiomas disponibles
Pre-instalación
Recomendaciones
The showerpanel should maintain all the
Ÿ
protective devices until the installation is
complete to avoid possible incidents.
Grasp the structure in order to move the
Ÿ
showerpanel; it shall never be dragged, nor
grasped through the pipes or external
components; is shall be placed horizontally
and not vertically.
Before the installation make sure that no
Ÿ
damages were caused during the
transportation.
The installation must be carried out by
Ÿ
qualified personnel and in compliance with
current local standards.
Pic.1
The pressure of mains water should not
Ÿ
exceed 5 bar and hot water temperature
should not exceed 55 ° C. It is imperative
to always respect those boundaries,
because their failure could result in
equipment damage.
The hydromassage column works properly
Ÿ
with a pressure of 2.5 bar. An excessively
low pressure or inadequate flow may
cause malfunction and loss of the
hidromassaje effects.
17
Hot and cold water connections should be
Ÿ
at an approximate distance as the
specified (Pic.1).
It is advisable to put safety valves in water
Ÿ
circuits.
Before installing the showerpanel, it is
Ÿ
advisable to clean and run water in the
pipes to avoid subsequent damage caused
by waste accumulated in the pipes (Pic.2).
Pic.2
COLD
HOT
It is recommended that the installation of
Ÿ
hot and cold water piping is made of
20mm diameter to ensure adequate flow
for the smooth running of the
showerpanel.
The hydromassage showerpanels have
Ÿ
flexible connections to the water outlets
with 700 mm length and a 1/2´´ male
link.
Publicidad
