ShelterLogic Kennel MDK 444 Manual página 4

3. ATTACH ROOF
With help, lift the roof assembly up
and over the assembled walls.
Position it so that the peak is on the
gated panel. The (4) corner bends
will insert into the outer tubes on the
front and rear of the kennel (do not
engage the "Pop" buttons yet). Fig. 4
The middle connection will go into the
middle connection that is closest to
the side bend (the cross rails are
two different lengths to accommodate
this offset). Fig. 5 Engage the "Pop"
buttons one at a time. After you have
inserted all of the "Pop" buttons go
around the kennel one more time
seating the roof completely (pull the
roof assembly all the way down).
Lastly, insert the #15237 plugs into
the open ends at the top of the wall
panels.
4. ATTACH FRONT PANEL
AND BACK PANEL
Secure the front and back panels to
the roof assembly using the "Hook
and Loop" straps. First secure the
peak and then the sides to be sure
the position is correct. Secure the
remaining straps once the panel is
in the correct position. Fig. 6
NOTE: The back panel is longer
than the front panel.
5. ATTACH COVER
Lay the cover over the frame, with the
ratchet with "S" hooks ends should be
at the front and rear of the kennel.
Hook the "S" hooks into the frame and
tighten the ratchets slightly.
Re-position the cover as needed to
make sure it is even front to back and
side to side. Finish tightening the
ratchets evenly by alternating corners
until secured tight. Fig. 7
Fig. 4
Fig. 6
Fig. 7
PAGE 4
Fig. 5
15237
Front Panel
Back Panel