Publicidad
Idiomas disponibles
Idiomas disponibles
NB:
When replacing the batteries in the universal remote control, the button functions
learned are retained.
EN
5.5.
DELETING LEARNED FUNCTIONS
Deleting a learned function
1.
2.
3.
4.
Deleting all learned functions
1.
2.
3.
4.
Restoring to default settings
1.
2.
3.
NB:
All of the settings configured for the device and the functions learned will be deleted
during the restoration to default settings.
6. MAINTENANCE
For your universal remote control, never use old and new batteries together. Old
batteries tend to leak and may result in decreased performance.
Do not use abrasive products or strong detergents to clean the universal remote control.
Protect the universal remote control from dust by cleaning it with a soft and dry cloth.
7. TROUBLESHOOTING
Simultaneously press the [MUTE] (22) and [VOL+] (6) buttons until the
Status LED (2) lights up solidly.
Select the device for which you want to delete a programmed function
(e.g. [TV], etc. ) using the device button. A compliance selection is
indicated by the Status LED (2) blinking then remaining lit.
Enter the code [9] [8] [1], and the Status LED (1) will blink twice then
remain lit solidly.
Press the button that you want to delete. The Status LED (2) will blink 4
times and the desired function will be deleted.
Simultaneously press the [MUTE] (22) and [VOL+] (6) buttons for 3
seconds until the Status LED (2) lights up solidly.
Select the device for which you want to delete all programmed functions
([TV], etc. ) using the device button. A compliance selection is indicated by
the Status LED (2) blinking then remaining lit.
Enter the code [9] [8] [2], and the Status LED (2) will blink twice then
remain lit solidly.
Press the [SETUP] button, and the Status LED (2) will blink 4 times and
all the learned functions will be deleted.
Simultaneously press the [SETUP] (9) button for approximately 3 seconds
until the Status LED (2) comes on solidly.
Press the [MUTE] button (22). The Status LED (2) will blink once then
stay solidly lit.
Press the [0] button. The Status LED (2) will blink 4 times and the remote
control will have been successfully reset to its default settings.
12
Publicidad
