Publicidad
Idiomas disponibles
Idiomas disponibles
Main parts of the product
(Fig.1 on page 3)
1. Lid
2. Magnet
3. Microswitch
4. Connection
5. Safety arm
6. Baffle
7. Electric box
8. PCB panel
9. Power cord
10. Bottom base
11. On-off switch
12. Motor
13. Motor cover
14. Spout
15. Upper of spout
16. Blade
17. Screw
18. Container
Remark: The content of this manual applies for all listed items
unless specified otherwise. The appearance may vary from the
shown illustrations.
Circuit diagram
(Fig.2 on page 4)
19. Green light
20. Microwave
21. Motor
Exploded diagram with part list
(Fig.3 on page 5)
Part
Part name
no.
1
2
Magnet
3
Cover
4
Microswitch
5
Connection
6
Screw
7
Sleeve
8
Safety arm
9
Upper of spout
10
Spout
11
Oil seal
12
Steel sheath
13
Screw
14
Motor upper cover
15
Cable tie
16
Strain relief
17
Power cord
Quantity
Lid
1
1
1
1
1
2
1
1
1
1
1
1
4
1
1
1
1
18
On -Off switch
19
Circuit board (Ver 3.0 2020-
12-03, LHSP-021-01)
20
Motor
21
Bottom base
22
Rubber feet(Black plastic)
23
Screw
24
Blade
25
Screw
26
Baffle
27
Container
Preparation before use
• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all ac-
cessories. In case of incomplete or damaged delivery, please
contact the supplier immediately. In this case, do not use the
device.
• Clean the accessories and the appliance before use (See ==>
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may emit
a light odor during the first few uses. This is normal and does
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
Operating instructions
1. Make sure the switch is in "OFF" status.
2. Place the ice cubes into the container.
3. Cover the lid on the container so that the magnetic sensor is
in contact with the end of the safety arm.
WARNING: Do not attempt to by-pass the safety interlock.
The appliance is equipped with a safety interlock to prevent
the end user from touching the moving parts.
4. Start the motor by pressing down the switch to "ON". Run the
appliance to crush the ice in the container ( It lasts about 30
seconds to finish crushing ice cubes in full container).
5. Switch the motor off by pressing down the switch again.
NOTE: Always wait until all components have completely
stopped before opening the lid.
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & mainte-
nance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
1
GB
1
1
1
4
1
1
4
1
1
9
Publicidad
