LUND 67012 Manual De Instrucciones página 10

Always disconnect the appliance from the power supply by taking the power cord out of the
socket before emptying the basket, replacing the UV lamp, or carrying out other mainte-
nance.
Keep the appliance away from sources of moisture and water. Never immerse the appliance
in water or any other liquid.
Do not insert fi ngers or other objects into the lamp when powered on.
Set the lamp in a place ensuring free air fl ow and where the UV lamp light is easily visible to
insects.
OPERATING THE LAMP
Preparing for operation
Unpack the appliance by removing all packaging components. The covers can be secured during transport with adhesive tape
which should be removed. Clean the external surfaces of the appliance according to the instructions contained in the "Appliance
maintenance" section. Set the appliance according to the instructions.
Turning the lamp on/off
Place the lamp in the place of use according to the recommendations.
Make sure that the inlet holes in the housing are closed (II). Plug the power cord into the socket, then open the inlet holes in the
housing by sliding the inner housing part (III) as far as it will go. In this way, the lamp is switched on. The UV lamp will light up
and the fan will start.
The lamp is switched off when the inlet openings are closed. The UV lamp will go out and the fan will stop after a short while.
Changing the UV lamp (IV)
Warning! Make sure the appliance is disconnected from the power supply before replacing the UV lamp. The power cord plug is
unplugged from the socket.
Disassemble the insect container. Remove all bolts securing the part of the lamp with the inlet holes to the lamp cover and then
carefully separate the two parts. Note that the parts are still connected with the fan supply wiring and care must be taken not to
damage it. The UV lamp is mounted under the lid. Loosen the lamp clamp bolt, turn the clamp, then remove the old lamp and install
a new one. Turn the clamp so that it holds the UV lamp. Fasten the lamp clamp bolt, assemble both parts of the lamp housing
with bolts and fi x the insect container.
Lamp maintenance
Warning! Before maintenance, make sure that the appliance is disconnected from the power supply. The power cord plug is
unplugged from the socket.
Rotate the insect container according to the arrow aiming at the open padlock symbol, and then slide it out of the housing.
Remove the mesh funnel from the container and then empty the container of insects.
The container and mesh can be cleaned with a soft brush or a brush with plastic bristles. Be careful not to damage both compo-
nents during cleaning. Both components can also be cleaned with a stream of lukewarm, running water or by immersing them
in water. A small amount of dishwashing liquid can be used for cleaning. In case of wet cleaning, dry the container and funnel
thoroughly before reinstalling them in the lamp.
Clean other parts of the lamp with a damp cloth, then dry or leave them to dry. Do not immerse the lamp in water or any other liquid.
TECHNICAL DATA
Parameter
Part no.
Rated voltage
Rated frequency
Rated power
Protection class
UV lamp wavelength
Operation area
Protection rating
Weight
O R I G I N A L
10
EN
Unit
[VAC]
[Hz]
[W]
[nm]
[m ]
2
[kg]
I N S T R U C T I O N S
Value
67012
220-240
50/60
15
II
365
60
IPX0
0.52