Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
Installation
All the operations concerned with the installation (electrical connection) must be carried out by qualifed technicians, in
terms with the standards in force, for specifc instructions, kindly read the part reserved for the installation technician.
Use
Gas burners(fg. 1)
The ignition of the gas burner is carried out by putting a small fame to the upper part holes of the burner, pressing
and rotating the corresponding knob in an anti-clockwise manner, until the maximum position has coincided with the
marker. When the gas burner has been turned on, adjust the fame according to need. The minimum position is found
at the end of the anti-clockwise rotation direction.
In models with automatic ignition, operate the knob as described above, pressing simultaneously, the corresponding
push-button. For models with automatic/simultaneous (with one hand) ignition, it is suffcient to proceed as described
above using the corresponding knob. The electric, spark, between the ignition plug and the burner provides the ignition
of the burner itself After ignition, immediately release the push-button and adjust the fame according to need.
For models with a thermoelectric safety system, the burner is ignited as in the various cases described above, keeping
the knob fully pressed on the maximum position for approximately 3/5 seconds. After releasing the knob, make sure
the burner is actually lit.
N.B.:- we recommend the use of pots and pans with a diameter matching that of the burner, thus preventing the fame
from escaping from the bottom part and surrounding the pot
- do not leave any empty pots or pans on the fre
- do not use any tools for grill-cooking on Crystal hobs.
When cooking is fnished, it is also a good norm to close the main gas pipe tap and/or cylinder.
GAS
* with reduction grid
Fig. 1
Ф 18 x 24
fast
Ф 14 x 18
semifast
Ф 12 x 14
auxiliary
fsh*
18 x 30
11
Publicidad
