Trust START-LINE OWH-002 Manual De Instrucciones página 7

OWH-002 SPLASH PROOF JUNCTION BOX
EN
1. Open junction box
Loosen the 4 screws on each corner with a screwdriver and remove the cover plate. The screws are
fixed to the cover, so they cannot fall out.
2. Position and secure cable glands
Position and secure the cable glands in the position where the wires will be threaded through.
3. Switch off the mains power (electric meter box)
4. Connect wires
Connect the wiring as described in the receiver's installation manual. If applicable, connect the earth
wires to the terminal block in the corner of the junction box.
5. Position and secure receiver
The receiver can only be positioned in 1 way. Once in position, secure the receiver with screws.
6. Tighten cable glands
Tighten the cable glands by turning clockwise to protect the inside from dust and moist. Use 7-12 mm
diameter cable for an optimal seal. Other cable sizes can negatively affect the waterproofness of the
junction box.
7. Mount junction box
Affix the junction box onto a wall or another surface for extra stability.
8. Switch on the mains power (electric meter box) to continue the installation
Shock hazard! Do not contact any exposed wiring. Only touch the plastic housing of this product.
9. Assign Trust Smart Home transmitter code
Read the receiver's manual for the code learning procedure.
1