ELECTRICSUN Paula glass black small 48 Instrucciones De Montaje página 3

Fig. A (1) Fig. A (2) Fig. B Fig. C
Step 2: Secure the unit to the back wall using the 4 screws (A) as shown in Fig. B.
Step 3: Replace the front cover and secure it with two mounting screws (See Fig. C).4
Type 2. Wall Hanging
Step 1: Select the wall location where you want to hang your electric heater. Draw a horizontal line using a level and mark 4 drill
holes for the 4 anchor screws.
Note: The holes are for mounting of heater and it shall be level so that the heater can be mounted properly and leveled.
Step 2: Drill 4 holes 8 mm (5/16in) in diameter and 43 mm (1.7in) deep on the marked locations. For holes that do not hit stud, use
the supplied wall anchor. Install the wall anchors into the holes and gently tap them into place with a hammer until the flange of
the wall anchor is flush with the wall surface. See Fig. B.
Step 3: Secure the mounting bracket to the wall anchors using the 4 anchor screws and 4 washers as shown in Fig. C.
Fig. C Fig. D (1) Fig. D (2)
Step 4: (1) Find the two mounting screws and remove them. (2)Remove the front cover by pulling it upward (See Fig. D (1) and Fig.D
(2)).
Step 5: Mount the heater on wall using the keyhole slots of the metal bracket at the back of the heater. See Fig. E.
Make sure that the mounting bracket is completely engaged into the metal bracket at the back of the heater.
Fig. E Fig. F Fig. G
Step 6: Secure the mounting bracket to the heater using 2 mounting screws. See Fig. F.
Step 7：Replace the front cover and secure it with two mounting screws (See Fig. G).
Fig. A
Type 3. Portable/Standing
Fix the bracket (F) by installing 4 screws (G). See Fig. A.
REPLACING THE DECORATIVE ACCESSORIES:
Step 1: (1)Find the two mounting screws and remove them. (2)Remove the front cover by pulling it upward (See Fig. A(1)and
Fig.A(2)).
3